FilterStream V2100 - Manual (Page 7)

7
M O U N T A B L E C H A R G I N G B A S E
The Charging Base recharges your DirtTamer ™
V2100 vacuum and stores the vacuum with its
cleaning tools for convenient access.
The Charging Base can be mounted vertically
(see Figure A) or placed on a horizontal surface
such as a counter, shelf, etc.
If you choose to wall mount the Charging Base,
please follow these steps:
1. Pick a convenient position within 6 feet of an
electrical outlet. If the Charging Base will be
mounted closer to an outlet, wrap any excess
cord in the storage area on the back of the
Charging Base.
(Note: Do not use an outlet which is controlled
with a wall switch).
2. Place the Charging Base against the wall in the
desired location and mark the center of each hole.
3. Drill a 3/16” diameter hole through the center of
the top mark. Push a Plastic Wall Anchor into the
drilled hole.
4. Insert one of the included screws and turn it until
the screw head is 1/4” above the wall surface.
5. Recheck that
the hole
alignment is
straight, then
drill the
second hole
and install the
other Plastic
Wall Anchor
and Screw.
6. Slide the
Charging Base
into place
making sure
the cord exits
through one
of the slots.
Wall
Mounting
Base
Charging
Plug
Figure A