Falcon Graphics RJ-6000 Series - Manual (Page 39)

Loading Cut Media
Step 1
Open the cover, check that head is in a
position where it will not touch the
media keeper blade and put the hold
lever up.
Step 2 Selecting media
Press the [MEDIA] key on the Control
panel to light the Sheet media LED.
Step 3 Loading media
Insert seasoned media between the
pressure roller and the drive roller.
Step 4
Align the right edge of the media with
the middle of the guide line (holes).
• The guide line (holes) is a guide
There is a possibility of a media jam if the pressure roller is not
holding the left edge of the media and the pressure roller is
near the right edge. Either hold the left edge of the media com-
pletely with the pressure roller or slide it so that pressure roller
is about 5 mm away from the right edge of the media and the
right edge of the media is within 5 mm to the left or right of the
guide line (holes).
38 RJ-6000 Series USER GUIDE Basic Edition
Loading the Media
Loading Cut Media
Hold Lever
: Lit
: Not lit
IMPORTANT