Auto off/delay on timer, Power on/off, Fan speed – FilterStream Ultra High Efficiency Air Purifier HW_A710 User Manual
Page 11: Using the auto off timer

Page 9
makes life better!
Power On/Off
The
1.
POWER CORD is shipped as two pieces.
Connect the two pieces, plug the end with
wall outlet prongs into an electrical outlet,
and the round end into the POWER JACK
located at the back of your AirTamer®.
Press the
2.
POWER BUTTON to turn the unit
on. The POWER BUTTON will illuminate
when on.
Fan Speed
Your unit will initially start at the highest speed – Speed 5. Select your
desired fan speed by pressing the corresponding SPEED BUTTON.
Your AirTamer® has five (5) SPEED SETTINGS 1, 2, 3, 4, and 5.
SPEED 5
will provide the highest rate of cleaning performance, but more noise.
SPEED 1
will provide the least amount of noise, but a slower rate of cleaning.
Normally, the lower speeds are ideal for sleep or relaxation environments.
Auto Off/Delay On Timer
You can run your AirTamer® continuously, or set it to TURN OFF
automatically in 2, 4, 6, 8 or 12 hours. You can also set your AirTamer®
to TURN ON automatically in 2, 4, 6, 8 or 12 hours.
Please see the following directions.
Using the Auto Off Timer
The AUTO OFF feature automatically shuts your unit off after 2, 4, 6, 8, or 12
hours. To use the AUTO OFF feature, follow these steps:
Press the
1.
POWER BUTTON to turn the unit on if not on already.
Press the
2.
AUTO OFF BUTTON. The AUTO OFF BUTTON and 2 TIMER
BUTTON will illuminate.
Press the
3.
TIMER BUTTON for your selected delay on time: 2, 4, 6, 8 or
12 hours later.
Select your speed level.
4.
HW_A710_UserMan_ENG_05.indd 9
5/14/09 9:04:17 AM