Farenheit Technologies TID-360 - Manual (Page 6)

Page - 5
Wiring Connections
Make sure you have good chassis ground. A good ground connection will eliminate most electrical
noise problems. A good
chassis ground requires a
tight connection to the
vehicle’s metal chassis.
The area around the
ground connection should
be clean, bare metal
without rust, paint, plastic,
dust, or dirt for a good
electrical connection.
**
TV antenna is for TID-360T
only.
Caution:
Do not
interchange the connection
of the wiring!!!
For some car models you
may need to modify wiring
of the supplied power cord.
Contact your authorized
car dealer before installing
this unit.
Using the ISO Connector
1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle carefully before
connecting, incorrect connection may cause serious damage to this unit.
3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the
color code table below for speaker and power cable connections.
Location Function
Connector A Connector B
1 Rear Right(+)---Purple
2 Rear Right(-)---Purple/Black Stripe
3 Front Right(+)---Grey
4
Battery 12V
(+)/yellow
Front Right(-)---Grey/Black Stripe
5 Auto Antenna/blue Front Left(+)---White
6 Front Left((-)---White/Black Stripe
7 ACC+/red Rear Left(+)---Green
8 Ground/black Rear Left(-)---Green/Black Stripe