Fujitsu Siemens Computers Pocket LOOX N100 Series - Manual (Page 22)

Operating the Pocket PC
Optimising battery operating time
The maximum operating time depends on the different applications, as these can consume more or
less energy. You can make settings in the system settings to help you to save energy when using
your Pocket PC. These settings enable you to use the battery operating time optimally.
i
In the default setting, a setting is activated that automatically switches the Pocket PC into
the Suspend mode after three minutes when working without a power connection if no
entries are made during this time. You can switch on the Pocket PC again at any time by
briefly pressing the Suspend/Resume button and then continue working where you left off.
Start Pocket PC for the first time
2
1
► Press the Suspend/Resume button (1) to switch on the Pocket PC.
► Pull out the stylus (2) in the direction of the arrow.
Adjusting display
i
Further information on orienting the display can be found in the chapter "Device settings"
in the section on "Adjusting display".
You can operate the Pocket PC not only with the stylus but also using your fingers.
Start screen
Following the introduction the start screen appears. The start screen shows all important current
information at a glance. From this screen you have access to all programs and to the system
settings:
14 A26391-K197-Z120-1-7619, Edition 1