Firstech, LLC. CM4200 - Manual (Page 47)

- 47 -
1WFM6R
1. Enter programming by pressing:
a. The (trunk) button, and the (start) button simultaneously until
the parking lights flash once. This is Menu 1.
b. The (trunk) button, and the (stop) button simultaneously until
the parking lights flash once. This is Menu 2 .
2. Press the (stop) button until the parking lights flash, the number of
times equal to the option you would like to change. For example, if it
were the 5
th
option in the menu that you would like to change, you
would press the (stop) button five times.
5. Wait a few seconds, and the parking lights will flash the number of
times corresponding to the option number you are about to modify. If
the number of times the lights flash does not correspond with the
option you want to change, wait a few seconds and the siren/horn will
sound, signaling that you have exited programming mode. After the
siren/horn sounds, you can retry the process from the beginning.
6. Immediately after the parking lights stop flashing from step 3, press:
a. The (unlock) button for the factory default setting. The parking
lights will flash once.
b. The (start) button until the parking lights flash, for the optional
setting. The parking lights will flash twice.
You will need to perform these steps for each option you would like to change.
2WFMR-S, 2WAMR, 2WFMR, and 2W900FMR
1. Enter programming by pressing:
c. Button ( I ), and button ( II ) simultaneously until the parking
lights flash once. This is Menu 1.
d. Button ( I ), and button ( IV ) simultaneously until the parking
lights flash once. This is Menu 2.
2. Tap button ( IV ) the number of times equal to the option you would
like to change. For example, if it were the 5
th
option in the menu that
you would like to change, you would tap button ( IV ) five times. The
CompuStar system will flash the parking lights once each time you tap
button ( IV ).