Resetting all of menu #1 or menu #2 – Firstech, LLC. CM4200 User Manual
Page 48
- 48 -
3. Wait a few seconds, and the parking lights will flash the number of
times corresponding to the option number you are about to modify. If
the number of times the lights flash does not correspond with the
option you want to change, wait a few seconds and the siren/horn will
sound, signaling that you have exited programming mode. After the
siren/horn sounds, you can retry the process from the beginning.
4. Immediately after the parking lights stop flashing from step 3, press:
a. Button ( I ) for the factory default setting. The parking lights
will flash once.
b. Button ( II ) for the optional setting. The parking lights will
flash twice.
You will need to perform these steps for each option you would like to change.
2WSSR
The 2WSSR programs options just like the other 2-way remotes listed above, but a more
focused approach may be needed. Inherent to the type of technology used in the 2WSSR,
is a noticeably longer delay in the response time. Given the delayed response time, and
that the option programming is a timed process in itself, option programming with this
remote can be a more difficult process if you are not sure of which buttons you need to
press during the process. Another option is the below mentioned Option Programmer,
which eliminates the need for remote option programming altogether.
CM3 Series Option Programmer
The Option Programmer is an installer’s tool used to modify options within the
CompuStar System. This unit plugs into the CompuStar system through the antenna cable
and is powered through this cable as well, therefore requiring no batteries to replace. The
Option Programmer makes it easier to program options available to remote programming
and also makes available some options that the remotes are unable to modify. The Option
Programmer has its own user’s guide in the “Accessory Manuals” section.
Resetting all of Menu #1 or Menu #2
to the factory default settings.
If you are not sure about current programming, you can change everything to the factory
settings and start again.