Firstech, LLC. CM4200 - Manual (Page 20)

- 20 -
CM-3000 WIRING DETAIL
CONNECTOR 1
Pin 1 Red- Constant 12-volt (+) positive power input for the control module. This wire
must be connected to a constant 12-volt (+) positive source. The proper wire will
test 12-volt (+) positive with the key in the off position, while key is in the on
position and during crank.
Pin 2 Green/White- Parking light (+) positive output. Connect this wire to the (+)
positive parking light wire generally at the parking light switch or behind the fuse
box. The proper wire will test 12-volts (+) positive when the parking light switch is
in the on position.
Pin 3 Red/White- Constant 12-volt (+) positive power input for the starter and accessory
on-board relays. This wire must be connected to a constant 12-volt (+) positive
source. The proper wire will test 12-volts (+) positive with the key in the off
position, while the key is in the on position and during crank
Pin 4 White- Accessory 12-volts (+) positive output. This wire must be connected to the
heater and A/C blower motor wire. The proper wire will test 0-volts with the key in
the off position, 12-volts (+) positive while key is in the on position, 0-volts while
cranking and back to 12-volts (+) positive with the key in the on position
.
Pin 5 Violet- 250mA (-) negative output when armed and remote started. This wire will
provide a (-) negative output when system is locked and armed and during remote
start for anti-grind. (Note: This wire can also be used to trigger after-market L.E.D.
kits and other after-market accessories. Output must be diode isolated when used to
trigger after-market accessories.)
Pin 6 Yellow- Starter 12-volt (+) positive output. This is pre-wired to pin 87a of the
starter interrupt relay. This wire will provide12-volts (+) positive to the vehicles
starter. The proper wire will test 0-volts with the key in the off position, 0-volts
while the key is in the on position and 12-volts (+) positive during crank. (Note:
The vehicle starter wire will need to be cut. The yellow wire from pin 87a on the
starter interrupt relay will go to the starter side of the vehicles starter wire. The
yellow/black wire from pin 30 of the starter interrupt relay will go to the key side of
the vehicles starter wire.)
Pin 7 Green and Red –Ignition output and input. This wire must be connected to the
vehicles ignition to power up all accessories and to trigger remote programming.
The proper wire will test 0-volts with the key in the off position, 12-volts (+)
positive while the key is in the on position and 12-volts (+) positive during crank.
(Note: Red wire is the ignition input for the pre-wired starter kill relay.)