Frymaster Pro H55-Series - Manual (Page 48)

6-8
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
(Continued from
previous page.)
C. Missing paper in filter pan. (This
causes too much pressure in the
oil return lines, resulting in a
strong flow through the Power
Shower, but also squirting of oil
from around the gasket.)
C. Verify that filter paper is properly
installed in the filter pan.
6.5
Troubleshooting the Basket Lift
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
Basket lift
movement is jerky
and/or noisy.
Basket lift rods need lubrication.
Lubricate basket lift rods with
Lubriplate™ or equivalent light
white grease.
6.6 Replacing the Controller or Controller Wiring Harness
1. Disconnect the fryer from the electrical supply. The controller bezel in held in place by tabs at
the top and bottom. Slide the bezel up to disengage the lower tabs. Then slide the bezel down to
disengage the upper tabs. Remove the top two screws holding the controller to the control panel
frame. Swing the panel open from the top, allowing it to rest on its hinge tabs.
2. Disconnect the wiring harness from the back of the controller and, if replacing the harness,
disconnect it from the interface board.
3. Disconnect the ground wire from the controller and remove the controller by lifting it from the
hinge slots in the control panel frame.
4. Reverse the procedure to install a new controller or wiring harness.
Ignition Module
Wiring Harness Connector Ground Wire