Graco Trabon LC-1000 - Manual (Page 8)

Your Program Record
Company: _____________________________________ By: _______________________
Machine Identifi cation: __________________ Date: _____________________
System Type: Bi-Flo ___ Piston Distributor ___ Series ___ Other: _________________
On (Monitor) Value: Time/Count _____ Seconds ___ Minutes ____Hours ___ Counts _____
Off Value: Time/Count _______ Seconds ______ Minutes ______ Hours ____ Counts ______
Cycle Value (Switch Transitions): ______________________
Pump On (Pulsed/Non Pulsed): ____________ (00 is NonPulsed)
TROUBLESHOOTING
Symptom Cause Remedy
Blank Display, No LEDs
No Power Check Wiring & Fuse-Repair as Required
Bad Circuit Board Replace Circuit Board
No Display or Black Dis-
play, but System Operates
Temperature too High or too Low Move Controller to Location that is within
Temperature Limits
Bad Display Replace Circuit Board
Program Will Not Run
Programming Error or Bad Circuit
Board Review Instructions & Examples-Reprogram/
Replace Circuit Board as Required
In Programming Mode Exit by Pressing PRGM
Can’t Change Program
Programming Error or Bad
Circuit Board Review Instructions & Examples-Reprogram/
Replace Circuit Board as Required
Power Off Before Programming
Completed Complete the Programming Process Before
Removing Power
Fault Light On
No Cycle Input Check Cycle Switch & Wiring-Repair as Required
Level Sw. or HP Sw. Closed
(If Used) Check Reservoir Level and Operating Pressure-
Refi ll/Repair as Required
System Blockage Correct Blockage (see Bul 30101)
No Pump Flow or Low Flow Check Reservoir Level & Pump
Output-Refi ll/Repair as Required
Main Line Leaks Check & Repair as Required
Plugged Filter/Strainer Clean or Repair as Required
Monitor Time too Short Increase Monitor Time
Failure to Indicate a Fault
Cycle Count Set to 00 Set Cycle Count to Desired Number of Half-Cycles.
Programmed Machine Count
Mode, and Wire According to
Fig. 1 Program On and Off in Time Mode, or Wire per
Fig. 2.
Call today for product information or to request a demonstration.
1.800.USA.LUBE
(1-800-872-5823) or visit us at www.lubriquip.graco.com.
All written and visual data contained in this document are based on the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice
All other brand names or marks are used for identification purposes and are trademarks of their respective owners.
®2006 Graco Inc. Bulletin 14540, July 2000. Printed in U.S.A.