Global Machinery Company ATBR1650-3PK - Manual (Page 27)

12
Preparing the tool
Tool lubrication
This brad nailer/stapler requires lubrication BEFORE
initial use and BEFORE and AFTER each additional use
throughout its life.
1. Disconnect the air hose, turn the brad nailer/stapler
so the air inlet (3) is facing up. Place 3-4 drops of non
detergent oil into the air inlet. Do not use air tool oil as it
contains solvents which will damage the nailer/stapler’s
internal parts.
2. Lubricate the drive safety cover & slide guide (8), trigger
(2) and magazine slide mechanism periodically.
3. After lubrication, run brad nailer/stapler briefly. Wipe off
any excess oil from the adjustable deflector exhaust (1).
The work surface can become damaged by excessive
lubrication.
4. Brad nailer/stapler repairs must be done by a qualified
and experienced service dealer.
Apply a few drops of oil
to sliding mechanism of
the magazine.
Apply a few drops
of oil to the trigger
mechanism.
Apply a thin coat of
lightweight grease to
safety slide guides.
Place a few drops of
non-detergent oil into air
inlet before each use.