Operating the tool – Global Machinery Company ATBR1650-3PK User Manual

Page 44

Advertising
background image

14

Operating the tool

Firing mechanism

This tool operates on a single (full sequential actuation)

firing system.

Single (full sequential actuation) firing

To fire, grip tool firmly to maintain control, position the

contact safety nose (1) of tool onto work surface, and

squeeze trigger (4) to fire a fastener. Allow tool to recoil

away from work surface as fastener is driven.
This “full sequential actuation” method provides the most

accurate fastener placement.

Where to use framing nailer

Framing nailer guns are used mainly in heavy construction

applications. Some additional important safety applications

are as follows:
1. Fire fasteners into work surface only, never into materials

too hard to penetrate such as concrete and steel.

2. Do not drive fasteners on top of other fasteners, or with

the tool at too steep an angle as the fasteners may

ricochet causing personal injury.

3. Do not drive fasteners close to the edge of the workpiece.

The workpiece is likely to split allowing the fastener to fly

free or ricochet causing personal injury.

Checking the safety strike element

1. Disconnect the air hose from the framing gun nailer and

remove all fasteners from the magazine (7).

2. Make sure the trigger (4) and the contact safety nose (1)

move freely up and down.

3. Reconnect air hose to the framing nailer.

Loading & unloading the fasteners
CAUTION.

Always disconnect the hose before loading the

nailer. Make sure that nails are collated firmly and are not

bent. Select nails suitable for your work.
1. Slide back the latch (9) all

the way to the back of the

magazine (7) until the nail lock

(8) has been engaged (Fig. A).

2. Insert the strip of nails into

the nail top loading slot (6)

(Fig. B).

3. Tilt the framing gun forward

to allow the strip nails to slide

towards the front of the nail

magazine (7)

4. Press the nail lock (8) and the

latch (9) will spring forward,

securing the strip nails against

the firing chamber.

Adjusting depth of nailing
CAUTION.

Always disconnect the hose before adjusting the

depth of nailing.

IMPORTANT.

Always test the nail depth on a sample piece

of wood and establish whether the nail head is too deep or

proud of the surface.
1. To adjust the nail driving

depth, rotate the Depth

adjustment dial (2) at the

front of the adjustment plate,

rotate anticlockwise (up the

thread) for deeper nail driving

and likewise, rotate clockwise

(downwards) for a flush nail

driving (flat to surface),(Fig. C).

A

B

C

Advertising