Geemarc Jupiter 50 - Manual (Page 9)

SETTINGS
AREA & LONG DISTANCE CODE SETTING
Your telephone needs to distinguish between local and long distance
calls. First of all you have to program your area code:
• Press X button together with T button and hold them both for
2-3 seconds until the display shows “SET AREA CODE”. Use T
and S buttons to select the correct area code. Press OK button
to pass from one digit to another.
• When the area code setting has been completed, press OK
button once – the display will show “SET LDS CODE”. The unit
enters the long distance code.
• Press X button to exit the setting.
PHONE BOOK SETTING
• When the phone is ON-HOOK, press and hold key for 2-3
seconds to enter the number setting mode.
• Enter telephone number (maximum 18 digits). If the number is
longer than18 digits, the display will show “TOO LONG”
message. To correct wrong digit press X.
• After completing the number setting, press key again to
enter the name setting mode. In the bottom left hand corner a
flashing line will appear. Enter the name corresponding to the
number according to character keys below. To enter continuous
letters on the same button press OK to pass to the next
character.
• When number and name setting is completed, press key
once to store the desired entry in your phone book.
Note: If you want to
exit during the
setting, use X button.
Otherwise, the system
will exit the phone
book mode
automatically after 20
seconds of inactive
sate.
Characters Key Characters Key
M N O 6 Ц ШС 6 . , ? – 1 1
P Q R S 7 7 A B C 2 ? Д Ж 2
T U V 8 Ü 8 D E F 3 3
W X Y Z 9 9 G H I 4 4
0 + : ; 0 J K L 5 5
9