Site requirements, Minimum dimensions - hearth, Flue outlet positions – Stovax 7126 User Manual

Page 15

Advertising
background image

15

3.1 The appliance must stand on a non-combustible

constructional hearth which is at least 125mm thick with

the minimum dimensions as shown in diagram. If it is to be

SITE REQUIREMENTS

3. MINIMUM DIMENSIONS - HEARTH

1

150

150

225

500

A

Superimposed Hearth

(or area to be free of

combustible material)

Constructional

Hearth

Dimension

A

Stockton 7

789

Stockton 8

927

fitted in a raised setting consideration may need to be given

to extending the depth of the hearth to safely containing

any falling logs or embers.

3.2 The building must have a suitable load-bearing capacity for

the hearth and appliance.

• Consult a structural engineer for advice before proceeding

3.3 When fitting into an existing hearth check:

• That the appliance complies with current construction

regulations and is at least the minimum sizes shown

3.4 If there is no existing fireplace or chimney it is possible to

construct a suitable non-combustible housing and hearth

setting. The flue must be installed in accordance with all

local and national regulations and current rules in force .

• Check if adding a new chimney to your property requires

planning permission

3.5 Some houses are built using a timber frame construction

with high levels of thermal insulation. Isolate the appliance

from combustible materials, and provide sufficient

ventilation to maintain the heating efficiency.

Position On Roof

Minimum Clearances

A

On ridge or within 600mm

600mm above ridge

B

Elsewhere on roof

2300mm horizontally from roof surface and:

a) 1000mm above highest point of flue exit

from roof or

b) as high as the ridge

C

On pitched, within 2300mm horizontally to

openable window, dormer

1000mm above top of opening

D

Within 2300mm of another building

600mm above top of building

1. FLUE OUTLET POSITIONS

150mm

max

Vertical

Measurement

Terminal

Insulation

Flue

Horizontal

Measurement

Adjacent

Building

The vertical measurement is the lowest from either the

point of discharge or 150mm above insulation.

IMPORTANT: Seek specialist

advice if installing in a dwelling

with a thatched roof

Advertising