Starting – Grizzly H4517 User Manual
Page 10
Model H4517/H4518 Air Compressors
-8
-
STARTING
To start the air compressor:
1.
Make sure the compressor switch is in
the
OFF
position (lever with red cap
above pressure gauges shown in
Figure 4
) before connecting to the
power supply.
Figure 4.
ON/OFF lever.
Check the pressure gauge to see that the
tank pressure climbs to approximately 100-
115 PSI or around 8 BAR, then automati-
cally turns off.
Note—
If the compressor does not auto-
matically kick off, flip the ON/OFF switch to
OFF before the pressure gets too high.
See the Pressure Regulator section.
Operating this equipment has the
potential for flying debris to cause
eye injury. Always wear safety glass-
es or goggles when operating equip-
ment. Everyday glasses or reading
glasses only have impact resistant
lenses, they are not safety glasses.
Be certain the safety glasses you
wear meet the appropriate standards
of the American National Standards
Institute (ANSI).
2.
Close the drain valve, shown in
Figure 5
, so the tank can build up
pressure.
3.
Double check the oil level to make
sure it is at the proper height.
4.
Connect the compressor to the power
supply.
5.
Flip the switch to the ON position
(where it reads
AUTO
).
Figure 5.
Drain valve location.