GE DR-1200 - Manual (Page 11)

Rugged Dome Installation Manual Mounting the Unit
1038346B / February 2003 11
2.2 F LUSH -M OUNTING THE H OUSING
To flush-mount the housing, see Figure 9 and perform the following.
Back plate
Ceiling panel
Outer plate
Inner plate
M5x20 pan-head
double-washer
screws (3)
M4x12 pan-head
double-washer
screws (3)
(through housing
base)
Figure 9. Flush-mounting the housing
Note: Feed the cables through the ceiling panel, plates, and housing at the appropriate
time depending on whether you are using the flying lead and whether the cable is external
or internal to the mounting surface.
To prepare the ceiling panel perform the following.
1) Remove the ceiling panel from the ceiling.
2) Position the back of the outer plate on the ceiling panel at the
installation location.