GE DR-1200 User Manual

Page 13

Advertising
background image

Rugged Dome Installation Manual

Mounting the Unit

1038346B / February 2003

13

2.3 U

SING

P

ENDANT

-

AND

W

ALL

-M

OUNT

B

RACKETS

To install the housing on pendant-mount, extended-pendant-mount, or
wall-mount brackets, perform the following.

Note: The extended-pendant-mount bracket is extended with a piece of installer-provided
3/4-inch (1.9 cm) pipe that has standard NPT threads. The extension should be in the
bracket before performing the installation procedure.

Note: Feed the cables through the mounting surface, bracket, and housing at the
appropriate time depending on whether you are using the flying lead and whether the cable
is external or internal to the mounting surface.

To prepare the mounting surface perform the following.

1) Using the bracket surface as a template, mark the mounting holes

on the mounting surface.

2) Drill the mounting holes and a pass-through hole for the camera

cables.

3) Secure the bracket to the mounting surface with the provided

screws and anchors.

To install the housing into the bracket see Figure 10 and perform the
following.

Pendant or wall-mount

bracket

Mounting screws (3)

(through housing base)

Figure 10. Installing the housing into the bracket

Advertising
This manual is related to the following products: