GE ZX758C - Manual (Page 6)

Care and Cleaning
Stainless Steel Hood
6
For your
safety Before servicing or cleaning the unit, switch
power off at the service panel and lock the
service panel to prevent power from being
switched on accidentally. If the service panel
cannot be locked, fasten a tag or prominent
warning label to the panel.
Metal
grease
filters Clean the grease filter after 30 hours of “on”
time. A signal light will alert you when 30 hours
has passed.
Remove the grease filters and wash them
either by hand or in the dishwasher using
non-abrasive soap.
To clean, swish the filters in hot soapy water or
wash them in the dishwasher. Do not use abrasive
cleansers.
Charcoal
filters
(on some models)
NOTE: To remove filters,
push them back and
down using the knob.
Front
For proper operation, be sure to use
the lower set of filter holders.
If the model is not vented to the outside, the air
will be recirculated through disposable charcoal
filters that help remove smoke and odors.
The charcoal filters should be replaced when
they are noticeably dirty or discolored (usually
after 6 to 12 months, depending on hood
usage).
NOTE: DO NOT rinse, or put charcoal filters
in an automatic dishwasher.
The charcoal filters cannot be cleaned.
They must be replaced.
Order Charcoal Filter Kit (3 filters) WB02X10731.
This kit can be ordered from your GE Supplier.
NOTE: To remove the metal filters,
push them back and down using
the knob. Push the charcoal filters
back and down using the tab.
Front
For proper operation, be sure to use
the charcoal filters in the upper set
of filter holders and metal filters in
the lower set of filter holders.
Metal Filters
Charcoal Filters