GE RCA High Definition Television - Manual (Page 17)

Connections & Setup
Chapter 1 15
TV + Satellite Receiver + VCR
1. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR’s antenna output jack and to the ANTENNA/CABLE
ANALOG INPUT jack on the TV.
B. Connect the audio (white and red) cables to the VID2 L/MONO and R audio jacks on the
back of the TV and to the Audio Output jacks on the VCR.
C. Connect the video cable to the VID2 V (Video) jack on the back of the TV and to the video
output jack on the VCR.
2. Make sure cable or antenna is connected to your VCR.
Connect the coaxial cable from your cable outlet or antenna to the antenna input jack on the VCR.
3. Connect your Satellite Receiver to your TV.
Note: Use the best connection offered by your satellite receiver—if your satellite receiver has
component video jacks, connect those.
A. Connect the audio (white and red) cables to the VID1 L/MONO and R audio jacks on the
back of the TV and to the audio output jacks on the satellite receiver.
B. Connect the video cable to the VID1 V (Video) jack on the back of the TV and to the video
output jack on the satellite receiver.
C. If your satellite receiver has an S-Video jack, connect an S-Video cable (instead of the video
cable in step B) to the S-VIDEO jack on the TV and to the S-VIDEO output jack on the
satellite receiver.
4. Connect the coaxial cable from an off-air antenna to the ANTENNA DIGITAL INPUT jack.
Note: Do not connect a digital cable signal to this input.
Go to page 18