Grundig DUO GRP6000 - Manual (Page 19)

Technical information details
The technical information screen displays the hardware and software information
of the receiver. This information may be required by the service agent or service
call operator.
1 Press » «, select » SETUP « and press » OK «.
2 Select » TECHNICAL INFORMATION « and press » OK «.
Electricity consumption
The Receiver/Player will always switch to standby when you press the » « key,
but will still use energy running the clock and other functions of the Receiver/
Player. To minimise this energy drain, if you press and hold the »
« key, the
Receiver/Player will switch off all functions. In this mode the Receiver/Player only
uses a tiny amount of energy, but it will take a little longer to switch on. It will also
interrupt the aerial signal making
analogue TV viewing or recording
impossible. If you don’t press a key on the handset or the Receiver/Player within
24 hours, then the unit will automatically switch to this low power standby mode.
Notes on simultaneous operation
● The Receiver/Player will always switch on in TV mode . To switch to Disc
mode press » «, » « or » ! «
● The SVHS output will always provide a signal in TV mode , but must be
correctly set-up for Disc mode . (See “Selecting the video output socket” in
the Disc mode section of the user manual.
● The aspect ratio (4:3 or 16:9) of the signal is stored for TV mode and Disc
mode separately so the settings must be adjusted accordingly.
● The TV program reminder will occur in TV mode or Disc Mode. If you choose
to watch your chosen TV program when in Disc Mode, the Receiver/Player
will automatically switch to TV Mode and Stop Disc playback. If you choose
cancel the Disc playback will resume.
● When a timer event is set, the 2nd infra red controller is disabled to prevent
interruption.
Optional RF External Infrared Receiver kit
1 Connect the receiver adapter into the aerial socket of your 2nd TV and then
connect the aerial extension lead from the »
RF Out2 « socket on the
Receiver/Player to the adapter.
2 Place the Infrared Receiver on top of the TV or somewhere in view.
3 Follow the steps in the Advanced setup section of this book to configure
the Receiver/Player to work with the 2nd handset.
19
OTHER INFORMATION
TV MODE
9
9