Grundig DUO GRP6000 - Manual (Page 9)

Connecting the television and VCR …
… using aerial (RF) cables
1 Connect the cable of your TV aerial to the » Aerial In « socket on the Receiver/Player.
2 Connect the short aerial from the » Loop Through « socket to the » RF IN « socket, both
on the Receiver/Player.
3 Connect the long aerial lead from the » RF Out 1 « socket to your TV or VCR » Aerial
IN «
… using SCART cables
1 Plug the standard SCART cable (supplied) into the » TV « scart socket on the
Receiver/Player and the appropriate socket for RGB reproduction on the TV set. See TV
user guide for details on this.
2 Plug a standard SCART cable (not supplied) into the » VCR « scart socket on the
Receiver/Player and the TV socket on the VCR.
3 If required connect the other devices as shown in the diagram above.
4 If you wish to connect the Receiver/Player to your HiFi system for improved sound, plug
standard phono cables into the »
AUDIO OUT L R « sockets and into the appropriate
sockets on your HiFi system.
… using a Y/C cable (S-Video) and phono cables
1 Plug a standard Y/C cable into the » S-VIDEO « socket on the Receiver/Player and into
the appropriate socket (S-VIDEO IN) on the television.
2 Plug standard phono AV cables into the » AUDIO OUT L R « sockets on the
Receiver/Player and the appropriate sockets (AUDIO IN) on the television.
Note:
As this product is a combination product, this manual will deal with the two halves of the
product separately. To switch between the two modes (
TV mode and Disc mode ) press
the » « key.
If the Receiver/Player is connected via the » S-VIDEO « socket, before you can use Disc
mode , you must carry out the setting described in “Selecting the video output socket” in the
Disc section of this book.
9
CONNECTION AND PREPARATION
TV
Aerial