GE Monogram ZV750 - Manual (Page 8)

Installation Instructions
8
7 INSTALL DUCT COVERS AND
UTILITY BARS
• Separate the duct covers supplied with the hood.
• Discard the upper (inner) section.
• Insert the ZXR758 or ZXR7510 duct cover (with
vent holes) into the original lower section. Be sure
that the new duct section is inside the shorter
original section.
• Place the decorative duct covers on top of the hood.
• Insert the lower portion of the duct cover into the
impressions on the top of the hood.
• Extend the inner duct upwards to meet the ceiling
and support frame.
• Secure the duct cover to the frame with the 2 small
Phillips screws provided.
• Install the side utility bars as shown with screws
provided.
6 CONNECT ELECTRICAL
• Verify that power is turned off at the source.
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be
sure to use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.
• Insert house wiring through strain relief and
tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
lead or bare ground lead.
• Secure all connections with wire nuts on each
electrical connector.
• Push wires into junction box and replace cover.
Be sure wires are not pinched.
Mounting Screw Holes