GE Monogram ZV750 - Manual (Page 9)

Installation Instructions
9
9 FINALIZE INSTALLATION
• Remove the protective film covering the control
panel on the front face of the hood, and any other
packaging materials.
• Refer to the Owner’s Manual for operating
instructions.
Upper Charcoal
Filter Slots
Grasp Tab,
Lift and Pull Forward
8 INSTALL FILTERS
• Remove protective film on charcoal filters.
• Tip charcoal filters into the upper (top) slots at the
rear of the opening. Grasp the filter tab, lift and
pull forward until it rests in the front slots.
• Install all 3 charcoal filters.
• Remove protective film from grease filters.
• Tip the grease filter into the lower slots at the rear
of the opening. Lift the filter and pull the knob
forward until the filter rests on the slots.
• Install all 3 grease filters.
• To remove the filters, grasp the knob, push the
filter toward the rear and tilt downward. Grasp tabs
on charcoal filters, push toward the rear and tilt
downward.
Lower Grease
Filter Slots
Upper Charcoal
Filter Slots
Install Charcoal Filters
Install Grease Filters
Lower
Filter Slots
• There are two slots inside the back and front of the
hood. These slots will hold the charcoal filters and
stainless steel grease filters in place.