Gaggia Baby - Manual (Page 13)

ENGLISH
• 9 •
Description of parts:
FIG. 01
1 Main switch
2 Hot water/brew switch (pump)
3 On/off light
4 Steam switch (temperature)
5 Correct temperature light
6 Removable water tank
7 Steam/hot water knob
8 Turbo frother steam nozzle
(removeable)
9
Filterholder
10 1 cup filter (or coffee pod)
11 2 cup filter
12 Basin (removable)
13 “Perfect crema” device (OPTION)
14 Brewing head
15 Filterholder gasket
16 Shower disc holder
17 Shower disc
18 Tamper
19 Power cable and plug
20 Measuring spoon
21 Delivery spout
22 Tank cover
23 Grid (removable)
24 Cappuccino maker kit (OPTION)
25 Overflowing protection hole
26 Level indicator for the basin
Instructions for the power supply
cord
A A short power-supply cord is provided to
reduce risks of getting tangled up or tripping
over a longer cord.
B Longer extension cords are available and
may be used if care is exercised in their
use.
C If a long extension cord is used:
1 the marked electrical rating of the extension
cord should be at least as great as the electri-
cal rating of the appliance.
2 if the appliance is of the grounded type, the
extension cord should be a grounding type
3 the cable does not hang from the table to
avoid the risk of getting caught up in it.
Preparation:
1. Remove the water tank cover (22) and fill
with cold water to the MAX line indicated
on tank (6). See FIG. 2.
N.B. : Near the word MAX on the tank there is
the overflowing safety hole (25) in case of
tank overfilling.
The water tank can also be removed, after
removing the tank cover (22) using the
handle.
Re-install tank with water and cover (22).
2. Insert plug (19) into a suitable wall outlet (see
point 1 under “Caution”).
3. Turn the power switch (1) to “On”. The on/off
light (3) will switch on.
Make certain that the hot water/coffee switch
(2) and that the steam switch (4) are in the
“Off” position.
Starting up
This procedure fills the water boiler with fresh
water.
This should be done whenever the machine is
switched on.
This machine, featuring a pump to brew coffee,
is equipped with a self-priming system. Place an
empty cup under the brewing head (14), do not
insert filter holder and press hot water/coffee
switch (2) (pos. “On”).
You will hear the sound of the operating pump
and after few seconds, water will start to escape
from the brewing head (14).