Genie 3452535556 GCG User Manual

Page 15

Advertising
background image

3. Wiring.

Route wire (29) using either method shown
(Fig. 3-5).

Wires along rail are held in place with wire clips.

Wires can be slipped under the wire clips
already in place.

15

SAFE-T-BEAM

®

SYSTEM INSTALLATION

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

3

NOTE: The operator will not close the door
automatically unless the Safe-T-Beam

®

System is

installed.

1. Mounting brackets.

Mark both sides of garage door frame or wall 5"
above floor. (Fig. 3-1).

Hold bracket against door frame or wall.

Check if brackets extend out from wall far
enough, so tongue of bracket is beyond door,
tracks or any door hardware.

If not:
a. “STB” bracket extensions are available

at local dealer.

b. Blocks of wood, etc. may be substituted for

extensions.

Center bracket on your mark (Fig. 3-2).

Fasten each with 2 screws (44) (Fig. 3-2).

NOTE: Mounting brackets can be attached to the
floor using concrete anchors (not provided).

2. Mounting “STB” source and sensor.

If garage has only one garage door.

Determine which side of garage receives most
direct sunlight (Fig. 3-4).

Red LED should always be on sunny side
whenever possible (Fig. 3-4).

For multiple doors.

Preventing crossed signals is critical.

Place source and sensor modules on adjacent
doors facing in opposite directions (Fig. 3-4).

NOTE: To help prevent interference from sun, “STB”
sensors (Green LED) may be placed further away from
the door opening where they will spend more time
in shadows.

Slide source/sensor onto tongue of bracket until
it clicks into place (Fig. 3-3).

There should be no electrical power to the operator
while installing Safe-T-Beam System

®

wires. If you

have plugged in the power cord—UNPLUG IT NOW.

WARNING

FIG. 3-1 Mark door frame

.

FIG. 3-2 Mount
brackets

.

FIG. 3-3 Attaching
STB’s to brackets

.

[41]

FIG. 3-5 STB wiring methods

.

Sensor

Source

Red

Green

Power
Head

Sensor

Source

Red

Green

Power
Head

A

B

Dashed Line = striped wire

Solid Line = white wire

tongue

mark

center of

bracket

FIG. 3-4 STB

locations

.

#10-16 x 1-1/4"

[44]

SUN

ONE DOOR
GARAGE

THREE DOOR
GARAGE

RED

LED

RED

LED

GREEN

LED

RED

LED

GREEN

LED

GREEN

LED

GREEN

LED

RED

LED

RED

LED

RED

LED

GREEN

LED

GREEN

LED

TWO DOOR
GARAGE

Advertising
This manual is related to the following products: