Grizzly G1005Z User Manual
Page 33
G1005Z Mill/Drill
-31-
3. Put on heavy leather gloves to protect your
hands from possible injury if the spring
uncoils during the next step.
4. While holding the spring lock cover against
the side of the head stock so the cover stays
splined with the locking lug; loosen the cap
screw approximately
1
⁄
4
" (see
Figure 29).
A high tension coiled spring is underneath
the cover. Put on heavy leather gloves to
protect yours hands from possible injury
when removing the cover.
Figure 29. Loosening cover and cap screw.
5. Pull the cover outward just enough to
disengage the spring-cover lock slot from the
locking lug.
Note: It is important to keep a good grip
during this step. Letting go of the cover will
cause the spring to rapidly uncoil, which
could cause serious injury!
6. Rotate the cover counterclockwise to increase
spring tension, or let the cover slowly unwind
in the clockwise direction to reduce spring
tension.
7. Engage the next available spring-cover lock
slot with the locking lug and hold the spring
cover tightly against the side of the head
stock.
8. Tighten the lock nut against the spring cover
just until the cap screw stops, and then back
off the cap screw approximately
1
⁄
3
turn, or
just enough so there is no binding at complete
spindle travel.