Expansion cards, Hard drive, Expansion cards hard drive – Gateway 955 User Manual
Page 112
106
Chapter 6: Troubleshooting
www.gateway.com
The diskette drive LED is lit continuously
■
Remove the diskette from the drive. If the light stays on, try restarting your
server.
■
Turn off your server, then remove the combination drive and push it in
again to make sure the drive is seated correctly. For instructions, see
“Replacing the CD/diskette drive in the Flex Bay” on page 49
.
Expansion cards
Your server does not recognize an expansion card
■
Restart your server.
■
Make sure that you have installed the necessary software or driver. For
instructions, see the card’s documentation.
■
Reseat the expansion card and the riser card. For instructions, see
“Installing PCI expansion cards” on page 60
Hard drive
The hard drive cannot be accessed, or you receive a “General failure
reading drive C” error message
■
If a diskette is in the diskette drive, eject it and restart your server by
pressing the reset button.
■
Restart your server by pressing the reset button.
■
Turn off your server, then remove all hard drives and push them in again
to make sure the drives are seated correctly. For instructions, see
■
Run a verification from the SCSI BIOS.
■
If your server has been subjected to static electricity or physical shock, you
may need to reinstall the operating system.
You receive a “Non-system disk” or “disk error” error message
■
Eject the diskette from the diskette drive, then press E
NTER
.
■
Make sure that your hard drive has an active partition. For more
information, see