Gateway 955 - Manual (Page 90)

84
Chapter 4: Installing Components
www.gateway.com
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on
page 45 .
2
Follow the instructions in “Opening the server case” on page 46 .
3
Remove the memory modules. For instructions, see “Installing memory”
on page 58 .
4
Remove the riser cards. For instructions, see “Installing PCI expansion
cards” on page 60 .
5
Remove the fan module. For instructions, see “Replacing the fan module”
on page 64 .
6
Remove the heat sinks and processors. For instructions, see “Installing a
processor” on page 67 .
7
Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)