GE 27959 - Manual (Page 14)

14
1. Press the flash/program button until SET RING LEVEL >1HI 2LO 3OFF
shows in the display. The default setting is 1HI.
2. Use the touch-tone pad to select 1, 2, or 3 or use the cid/messages (< or
>) buttons to scroll to 1HI, 2LO, or 3OFF.
3. Press flash/program again to store your selection. You will hear a
confirmation tone (at the base only).
NOTE: If you turn the ringer OFF, “RINGER OFF” shows in the base display.
R
INGER
T
ONE
NOTE: This setting may be made with the base and the handset.
You may choose from three different ringer tones.
1. Press the flash/program button until SET RINGER TONE > 1 2 3 shows
on the base unit display or RINGER TONE > 1 shows on the handset
display. The default ringer tone is 1.
Prompt displayed on the base unit Prompt displayed on the handset
2. Use the touch-tone pad to select 1, 2, 3 or use the cid/messages (< or >)
buttons on the base unit or CID/VOL ( < or > ) buttons on the handset to
scroll to your selection. The ringer tone plays for few seconds.
3. Press flash/program again to store your selection. You will hear a
confirmation tone.
T
ONE
/P
ULSE
NOTE: This setting may only be made with the base.
SET RING LEVEL
>
1HI 2LO 3OFF
SET RINGER TONE
>
1 2 3 RINGER TONE > 1