GE CG709 - Manual (Page 47)

Playback on a TV (or VCR)
(continued)
45
Playback Operation
1. Choose 3CH/4CH using the switch on
the RF output adapter.
2. Turn on the TV and tune it to the same
channel you selected with the
3CH/4CH switch on the RF output
adapter.
3. Place the camcorder’s CAMERA/VCR
switch in VCR, and slide POWER.
4. Insert the cassette you want to play
back into the camcorder.
5. Press the PLAY button on the
camcorder.
6. Press the STOP/EJECT button on the
camcorder when you are finished
playing back the tape.
Watching What the Camcorder is Seeing or Recording on the TV
1. Turn on the TV and tune it to channel
3 or 4 (the same channel you selected
with the RF output adapter).
2. Place the camcorder’s CAMERA/VCR
switch in CAMERA, and slide
POWER. Insert the cassette you want
to record on.
Note: When the camcorder is used as a
camera, turn the TV’s volume down to
prevent a high-pitched squeal caused by
feedback. Remove the cassette.
3. Press the camcorder’s thumb trigger
(or PAUSE/STILL) to begin recording.
You can watch what the camcorder is
seeing or recording on the TV screen.
Normal TV Viewing
For normal TV viewing, you can leave
the RF output adapter hooked up to the
TV. Just disconnect the RF output
Note to Cable-TV Installer: This reminder is provided to call your attention to
Article 820-40 of the National Electrical Code (Section 54 of Canadian Electrical
Code, Part I), that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building as close to the point of cable entry as practical.
adapter’s plug from the camcorder so
you can watch the signal from your VHF
antenna.