Graham Field PATRIOT US0208 - Manual (Page 12)

US0208-INS-LAB-RevD11 • Patriot Homecare Bed 12
Full-electric bed only (US0458 / US0458PL):
Assemble hi/lo motor shaft to foot end gear box
notches in hi/lo motor shaft coupler
slide over gear box shaft pin
gear box
hi/lo motor shaft
hi/lo motor
Attach hi/lo motor shaft
to foot end gear box
FOOT
END
You must first attach the coupler end of the motor shaft to the foot-end gear box (see above).
1. Note the position of the hi/lo motor plug on the Okimat actuator next to the pendant hand
control plug — plug the hi/lo motor into the actuator, routing the hi/lo motor cord under the
fixed base frame cross-angle as shown below to ensure clearance with the hi/lo drive
shaft.
2. Plug the power cord into any grounded outlet.
3. Pull the motor shaft toward the foot end. Using the hi/lo function on your pendant hand con-
trol, slowly turn the hi/lo motor shaft until the coupler matches up with the gear box shaft pin
as shown above.
4. Slide the coupler until it rests completely on the pin. You may need to manipulate the foot end
slightly from side to side and/or lift the hi/lo motor itself for proper alignment.
5. Unplug the power cord.
Route cord under cross-angle
FOOT
HEAD