Stovax STUDIO 8700CFCHEC - Manual (Page 13)

13
IMPORTANT: REFER TO DATA BADGE AND TECHNICAL
SPECIFICATION AT THE FRONT OF THE MANUAL TO
ENSURE THE APPLIANCE IS CORRECTLY ADJUSTED FOR
THE GAS TYPE AND CATEGORY APPLIED IN THE
COUNTRY OF USE.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES
REFER TO SECTION 10, SERVICING, ‘REPLACING PARTS’.
1. SAFETY PRECAUTIONS
1.1 For your own and other’s safety, you must install this
appliance according to local and national codes of practice.
Failure to install the stove correctly could lead to
prosecution:
• Read these instructions before installing and using this
stove.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
1.4 Keep all plastic bags away from young children.
1.5 Do not place any object on or near to the appliance and
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
2. INSTALLATION OF THE APPLIANCE
1.1 This appliance can be installed in four different ways:
1) Builder’s opening with a frame
2) Builder’s opening without a frame
3) Stud work with a frame
4) Stud work without a frame
Where no frame is used an edge kit is available to enable
the installer to plaster to a finished edge: Kit No. 8727
CFFK01 for Studio 1 and 8727 CFFK02 for Studio 2
Options 1) and 2) above can be:
• top exit with a liner
• rear exit without a liner
1.2 The Studio is supplied with a flue fixing plate to attach the
flue to the appliance within the aperture, Diagram 1.
AR1010
1
When installing the appliance into a masonry chimney
without a liner, it must be converted to a rear exit:
• Remove the two fixing screws securing the spigot
assembly
• Slide the blanking plate into the guides
• Replace the two fixing screws, Diagram 2
AR2007
2
The flue must be in good condition and clear products of
combustion, see Commissioning)
Option 3) and 4) must be fitted using the top exit only with
rigid twin wall flue pipe.
THE APPLIANCE IS SUPPLIED WITH A WALL BOX
CONTAINING THE BATTERIES AND TOUCH PAD. THIS
MUST BE RECESSED INTO THE WALL WITH ACCESS
FOR THE CABLES PRIOR TO FITTING THE APPLIANCE.
2.1 Remove the appliance from the carton and discard all
unnecessary packaging. Ensure no components are thrown
away when unpacking.
2.2 To access the controls and gas inlet:
• Remove the glass door, enamelled liners, burner and
splitter plate. See Section 4
2.3 The gas supply enters the fire through a silicon panel on the
floor under the access panel, Diagram 3:
• Slit with a sharp knife before bringing through the supply
pipe, Diagram 1
INSTALLATION INSTRUCTIONS
INSTALLATION