GE Panel C GFK-2251 - Manual (Page 49)

GFK-2251 6-1
BIOS Settings
It is normally not necessary to change the hardware configuration settings in the CMOS
memory. If settings become corrupted, follow the procedures here to reload the factory
configuration.
1 . Power down the computer, connect a keyboard and turn on the power. Enter the
Setup mode by pressing the F2 key when prompted during the computer power-up
sequence. The main BIOS setup utility screen will appear offering several options for
changing settings.
2 . In the EXIT menu - Load BIOS defaults.
3 . In the ADVANCED menu, select Installed OS. Change to “Other.”
4 . Arrow to IO Device Configuration. Press E NTER .
5 . Make the following menu selections:
USB Disable
Audio Disable
COM: A (COM1 on side) 3F8 / IRQ 4
COM: B (COM2, touch screen) 2F8 / IRQ3
COM: C (COM3 on side) 3E8 / IRQ 9
COM: D (COM4 on front) 2E8 / IRQ11
LPT:A (LPT1 on front) ECP / 378 / IRQ7 / DMA3
LPT:B (LPT2 on side) ECP / 278 / IRQ5/ DMA0
6 . To save your changes, press E SC . In the Exit menu, select Exit Saving Changes.
6
Chapter