Graco 258906 - Manual (Page 19)

Motor Control Board
3A0246C 19
11. Connect potentiometer connector (C) to motor con-
trol board (24).
12. Connect Prime/Tool Fill/Recirculate reed switch con-
nector (E) to motor control board (24).
13. Replace control panel (37) and tighten bottom two
screws (61). Torque to 30-35 in-lb.
14. Connect display connector to motor control board
(24).
15. Assemble display cover (33k). Spring tabs on noise
shield need to be assembled to the inside of the
control box enclosure. Torque screws to 30-35 in-lb.
16. Replace motor shroud (98) and torque four screws
(40) to 30 - 34 in-lb.
17. Reconnect material hose (79) to pump (18a).
18. Replace Power Module, see page 7.
ti15791a
C
24
ti13572a
E
24
ti15795a
61
37
ti13569a
24
ti15786a
33k
ti15624a
98
40
ti15616a
79
18a