Graco 258906 - Manual (Page 22)

Pressure Transducer
22 3A0246C
2. Connect transducer connector (E) and reed switch
connector to control board (24).
3. Install control box (3) and control panel (37) with
four screws (61). Torque to 30 - 35 in-lb.
4. Connect potentiometer connector (D) and reed
switch connector (87) to control board (24).
5. Connect display connector (A) to motor control
board (24).
6. Install cover (33k) with four screws (33b). Torque to
30-35 in-lb. Make sure tabs on noise shield are
routed inside the control box when assembling.
24
E
ti12999a
61
37
3
61
ti15797a ti15795a
87
24 D
ti15792a
A
24
ti13569a
33b
33k
ti15786a