Auto lap – Garmin 910XT User Manual
Page 12
10
Training with Your Forerunner
NOTE: Advanced alerts are not available
in swim mode.
1
Select MODE > Training > run
Alerts.
2
Select an option:
• Select Hr Alert to set the high and
low heart rate values in beats per
minute (bpm).
NOTE: For more information about
• Select Cadence to set the
minimum and maximum cadence
amounts in steps per minute (spm)
or revolutions of the crank arm per
minute (rpm).
• Select Power Alert to set the
minimum and maximum power in
watts.
NOTE: For more information about
3
Set the parameters for your alerts.
Each time you exceed or drop below the
specified heart rate or cadence amount,
the device beeps or vibrates and displays
a message.
Setting walk Break Alerts
Some running programs use timed
walking breaks at regular intervals. For
example, during a long training run, the
program may instruct you to run for four
minutes, then walk for 1 minute, and
repeat. Auto Lap functions correctly while
you are usig the run/walk alerts.
NOTE: Walk alerts are available only in
run mode.
1
Select MODE > Training > run
Alerts.
2
Select run/walk Alert > On.
3
Select run Alert, and enter a time.
4
Select walk Alert, and enter a time.
Each time you reach the alert amount, the
device beeps or vibrates and displays a
message. The run/walk alerts will repeat
until you stop the timer.
Auto Lap
NOTE: Auto Lap does not function during
interval or custom workouts or pool swim
mode.