GE Interlogix BusSecure - Manual (Page 26)

BusSecure Configuration BusSecure User Manual
26 0150-0263A / May 2003
Note: Once the Accept button is clicked, the buttons on the bottom of the screen change to a Save and Cancel button.
Clicking on Save at this point will cause your changes to be written and the BusSecure to reboot. If you have more
changes to make on the other configuration screens; first click Accept and then use the [Home][Configure][Upgrade]
selections at the top of the page to navigate back to the Configuration pages.
4.1.3 C ONFIGURE I NPUTS
Click on the Configure Inputs option to display the following screen:
The configuration options on this page include:
•
Name – User supplied input name or designation.
•
Type – Input type, Alarm, Trigger or Not Used.
•
Pre Trigger Time – Various increments from 0 seconds to 10 minutes.
•
Post Trigger Time – Various increments from 0 seconds to 10 minutes.
•
Camera Group – Select from Cameras 1 through 4.
A Reset Defaults button is also available. Click the Accept button to enter the changes or click the
Reset button to undo any changes.
Note: Once the Accept button is clicked, the buttons on the bottom of the screen change to a Save and Cancel button.
Clicking on Save at this point will cause your changes to be written and the BusSecure to reboot. If you have more
changes to make on the other configuration screens; first click Accept and then use the [Home][Configure][Upgrade]
selections at the top of the page to navigate back to the Configuration pages.