GBC VOYAGER 3 930-032 - Manual (Page 30)

Operations Manual: Installation
Voyager 3 Voyager 3
2004 General Binding Corporation Page 4-6
4.4 Positioning the components
All components are positioned by the center line of
the laminator. The components should be posi-
tioned in the following order; Laminator, stacker
table, feeder, conveyor, vacuum/ pump and then the
water heater. Refer to Figure 4.4.1 Component
Placement.
WARNING: Always consult your licensed
riggers before attempting to move the com-
ponents. You may be seriously injured and/
or cause damage to the machine.
WARNING: Do not attempt to move the
components of the GBC Voyager 3 across
anything other than a flat level surface with-
out trained and qualified riggers.
It is recommended to move each component in the
following manner but you should consult the
licensed riggers for alternative methods that best fit
your situation and surroundings.
WARNING: To safely move the components,
use as many people necessary to assist in
keeping the components stable during
movement.
CAUTION: Exercise safe lifting practices to
avoid serious injury to yourself and the
equipment.
Laminator
Once the laminator has been safely removed from
the crate, you can move the laminator into position
by using a pallet jack or forklift.
To move the laminator, approach the laminator from
the front and guide the forks under the laminator
where indicated on the laminator.
Stacker table
The stacker table can be easily carried by two peo-
ple and attached to the laminator once the lamina-
tor has been set into position.
To attach the stacker table, position the stacker
table hooks onto the stacker table support rod locat-
ed at the back of the laminator.
Fork Lift
Stacker table hook
Stacker table
support rod