Stovax Huntingdon 30 - Manual (Page 20)

20
9.1 • Open the door and remove the ceramics, placing them
carefully to one side.
• Undo the two screws in the back of the firebox and
carefully withdraw the bracket, Diagram 14 and 15
9.2 • Disconnect the two sensor wires
• Undo the two taptite screws
• Remove the sensor and the two plastic spacers, Diagram
16
9.3 • Refit the new sensor ensuring the plastic spacers are
located between the bracket and the sensor
• Refit the leads
AR1452
16
AR1446
15
AR1442
14
9. GAZCO FLUE SURE SYSTEM
9.4 • Feed the cable back through the hole as you replace the
bracket.
When the bracket is located correctly it sits flush with the
back panel without force. If not positioned correctly the
bracket sits at an angle, Diagram 17
10.1 Turn to Section 3.8 Removing the Door, in the
Installation Section of this manual.
• Remove the door and place to one side
• Remove the cover plate from the bottom of the stove by
undoing the screws, Diagram 18
• Undo the M5 nyloc nut from the bottom of the burner
unti and remove the aeration plate, Diagram 19
AR1924
18
10. PRIMARY AERATION PLATE
AR1448 AR1447
17
SERVICING INSTRUCTIONS
REPLACING PARTS