Grundig CDS2500IPW - Manual (Page 19)

TROUBLESHOOTING
16
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the
set as there is a risk of electric shock.
If you are unable to remedy the problem by following these hints, call Grundig Helpline: 1800 509
394 Australia Grundig Helpline: 0800 450 259 New Zealand.
Warning:
Under no circumstances should you try to repair the set yourself, as this will invalidate
the warranty
Problem
No sound / power
Display does not function
properly / No reaction to
operation of any of the
controls
The CD skips tracks
No disc indication
CD Playback does not work
USB / Memory card failure
Cause
Volume not adjusted
Power cord not securely
connected
Electrostatic discharge
CD damaged or dirty
Program is active
No CD inserted
CD badly scratched or dirty
Laser lens has steamed up
CD-R is blank or the disc is not
finalized
CD badly scratched or dirty
Laser lens steamed up
USB / Memoy Card connecting
error
USB / Memory Card does not
contain playable files
Solution
Adjust the Volume
Connect the AC cord properly
Switch off and unplug the set.
Reconnect after a few seconds
Replace or clean CD
Quit program mode
Insert a CD, CD-R or CD-RW
Replace or clean CD
Wait until lens has cleared
Use a finalized CD-R
Replace or clean CD
Wait until lens has adjusted to
room temperature
Unplug and reinsert memory
card or USB stick
Use a USB / Memory Card c
ontaining MP3 or WMA files