Radio – Grundig CDS2500IPW User Manual

Page 9

Advertising
background image

RADIO

6

ENGLISH

MANUAL TUNING
1. Press BAND button to select desired BAND (MW or FM).
2. Tune to the required station by pressing the or button.
3. Adujst volume control to the desired volume level.

AUTO TUNING
1.

Press BAND button to select desired band (MW or FM).

2. Press and hold the or button more than 1 second and then release.
3. The unit will start scanning automatically and stops when a radio station is reached.
4. Repeat steps 2 & 3 until a desired radio station is reached.
5. Adjust volume control to a desired volume level.

PRESET STATIONS
You can store up to a total of 40 radio stations in the memory (30-FM / 10-MW).

1. Set to TUNER mode.
2. Tune to the desired radio station by "MANUAL" or "AUTO" tuning methods.
3. Press MEMORY/CLOCK button , a preset memory blinking on the display.
4. Press the PRE+/PRE- buttons to select the desired preset memory
5. Press MEMORY/CLOCK button again to confirm .
6. Repeat steps 2 to 5 to store other stations.
7. Press the PRE+/PRE- buttons to recall the preset stations in order.
8. The unit will return to normal tuner mode do not press any button for 5 seconds.

FM & FM-STEREO RECEPTION



Press the MONO/ST. on remote handset to select MONO or STEREO
reception mode.

HINTS FOR BEST RECEPTION
MW: The receiver has a built-in MW ferrite antenna. If the MW reception is weak, rotate or reposition the

unit. This usually improves the MW reception.

FM: Attached FM wire antenna plugged in at the rear of the unit should be fully unwind and extended

its full length for best reception.

LISTENING TO THE RADIO

Advertising
This manual is related to the following products: