Maintenance and servicing, Removal of the log guard, Fitting and removal of firebricks – Stovax Stockton 7162 User Manual
Page 26: Fitting and removal of baffle, Fitting a new door glass
26
1.4 Using the appliance for the first time:
• Burn at a low output for the first day of use
This allows the seals, fixing glues and paint to fully cure.
1.5 During this time the appliance may give off some
unpleasant odours:
• Keep the room well ventilated to avoid a build-up of
fumes
1.6 Your Stovax dealer can carry out service and maintenance.
2. ReMoVAl oF THe loG GUARd
2.1 To remove the Log guard:
• Lift Log Guard clear of the supporting brackets
• Rotate to clear the sides of the door opening.
do not use appliance without the log guard in position.
3. FITTING ANd ReMoVAl oF FIReBRICKs
3.1 See Section 3 Fitting & Removal of Baffle in Installation
section.
4. FITTING ANd ReMoVAl oF BAFFle
4.1 See Section 4 Fitting & Removal of Baffle in Installation
section.
5. FITTING oPTIoNAl MUlTI-FUel KIT To
sToCKToN 5/6/7/8
5.1 See Section 5A and 5B Fitting Multi-fuel Kit in Installation
section.
6. FITTING A NeW dooR GlAss
6.1 To maintain the safe use of your stove you may need to
replace a damaged door glass.
6.2 To complete this operation:
• Open the door
• Lift it free of the hinge blocks
• Lie the door face down on a soft flat surface, to protect
the paintwork and glass
MAINTeNANCe and seRVICING
Fixing Screws (x4)
Fixing Clips (x4)
Glass
Glass Seal
Door
PR7080
Single Door
Fixing Screws (x10)
Fixing Clips (x4)
Fixing Clip Long (x2)
Glass (x2)
Glass Seal (3mm)
Door (x2)
PR7081
Double Door
• Remove the glass clip fixing screws (4)
• Lift the old glass can then be lifted clear of the door
(Note how the 3mm sealing rope is placed between the
glass and the door.)
• Dispose of the old glass safely
• Clean, and re-paint, the rear of the door if required
• Clean the screws with light oil
• Coat with high temperature anti-seize grease to aid future
removal
• Fit new sealing rope between the new glass and the door
• Place the glass into position in the door
• Place the glass fixing clips into position
• Re-fix with the clean fixing screws