Stovax Stockton 7162 - Manual (Page 27)

27
• Refit the door
• Close to apply pressure on the new rope
• Leave the appliance closed for at least 12 hours before
lighting the stove
• Use at a low output for approximately one day
7.3 Using the stove with a damaged door seal could allow
dangerous fumes to enter the room, or the appliance to
over-fire and cause damage.
8. AdJUsTING dooR HINGes
8.1 To maintain the safe use of your appliance, you may need
to adjust the door hinges to ensure the door closes safely
and correctly.
8.2 To complete this operation:
• Open the door to give access to the fixed part of the door
hinge as shown
Fixing Nut Lock Nut
PR7087 PR7086
• Use a 19mm A/F spanner to loosen the fixing nuts
• Reposition the hinge blocks to achieve a correct fit
This may require several adjustments to find the correct
position.
• Tighten the screws evenly until the clips hold the glass
Do not over tighten the clips as this could break the glass.
6.3 Fit only Stovax ceramic glass, which is suitable to use in
high temperature applications.
6.4 Using the appliance with damaged door glass could allow
dangerous fumes to enter the room, or the appliance to
over-fire and cause damage.
7. FITTING A NeW dooR seAl
7.1 To maintain the safe use of your appliance you may need to
replace a damaged or worn door sealing rope.
7.2 To complete this operation:
• Open the door
• Lift it free of the hinge blocks
• Lie the door face down on a soft flat surface, to protect
the paintwork and glass
Joint
Seal 14mm
Seal 14mm
Seal 10mm x 2mm
PR7084
PR7085
Single Door
Double Door
• Remove the old rope
• Scrape old glue from the locating groove
• Clean the locating groove with a clean dry cloth removing
all dust and debris
• Apply Stovax Thermic Seal glue (Stovax Part No. 5037)
into the rope locating groove
• Press the new Stovax rope into the locating groove,
placing the joint in the middle of the lower edge of the
door
MAINTeNANCe and seRVICING