GIGABYTE GA-7vkml - Manual (Page 25)

English
Hardware Installation Process - 21 -
7) RAM_LED Ø Do not remove memory modules while
DIMM LED is on. It might cause short or
other unex pected damages due to the
2.5V stand by voltage. Remove memory
modules only when AC Power cord is
disconnected.
+
-
8 ) F_PANEL (2x10 pins jumper)
Ø Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
HD+
MPD+
2 20
1 19
GD-
PW- PW+
RST-
SPK+
SPK-
1
1
RST+ HD- GD+
1
1
MPD-
GN- GN+ NC
1
1 1
GN (Green Switch) Open: Normal Operation
Close: Entering Green Mode
GD (Green LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
SPK (S peaker Connector) Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
RST (Reset Sw itch) Open: Normal Operation
Close: Reset H ardware System
PW (Soft Power Connector) Open: Normal Operation
Close: Power On/Off
MPD(Message LED/Power/ Pin 1: LED anode(+)
Sleep LED) Pin 2: LED cathode(-)