Garland MCO-GS-10E - Manual (Page 23)

23
Assembly
FILE NAME
JIT00012
7
6
2
1
3
8
5
4
5
9
1. Assemble motor mount plate, * insulation, motor mount plate inner together by
fastening four flat head m.s. 1/4-20x2½" into the four holes noted on the above drawings.
2. Secure each flat head m.s. 1/4-20x2½" with a flat washer and three hex nuts 1/4-20 .
3. Attach motor mounting plate to motor . Insert the four flat head m.s. 1/4-20x2½" through
the mounting tabs on motor as shown. Secure with two hex nuts 1/4-20 .
4. Insert shaft of motor through the hub of the blower wheel . Space the blower wheel
¼" away from the inner motor mounting plate .
5. Secure the blower wheel to the shaft of the motor by tightening the two set screws
on the blower wheel hub. Use a torque wrench and tighten to 180 inch pounds for proper
securing.
***** For warranty replacement we require that you use the motor assembly. Order motor
assembly part # CK1003090 - 2 Speed, 115 Vac, or CK1003091 2 Speed, 208/240 Vac (Export
or Special), CK1003092 - 1 Speed, 115,208,240 Vac.