GE JV935 - Manual (Page 11)

Installation Instructions
11
TOOLS AND MATERIALS
REQUIRED
(NOT SUPPLIED)
Pencil and
tape measure
Spirit level
Phillips and
Flat blade screwdrivers
Duct tape
Electric drill with
1/8 and 3/8 bits
1/4 pivoting hex socket
Safety glasses
Flashlight
Saber saw or Key Hole Saw
Metal Snips
Hammer
Pliers
Additional Materials:
• 120V 60Hz. 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
• Strain relief for junction box.
• 7
round metal duct or 3-1/4 x 12 rectangular duct,
length to suit installation.
Wire Cutter/
Stripper
Ladder
Allen
Wrench
CAUTION:
Lift hood by grasping the outside
edges of the inlet opening of the hood. Do not lift
hood by the exhaust opening divider–damage will
occur!
REMOVE THE PACKAGING
• Lift out the wooden crossmember, as well as the top
protective carton.
• Lift the hood out of the box.
• Remove shipping screws holding the wood mounting
piece to the back side of the hood. Set aside wood
mounting piece and screws for later installation.
Do not discard.
• Remove junction box cover and knockout.
• Install strain relief onto back or top of hood.
• Remove all tape and packing material from the
hood, duct transition and motor.
UL Listed Wire nuts
• Remove parts package from the shaped cardboard
insert.
“V”
• Remove the shaped carton insert. “V”
• Lift out the four “L” shaped polystyrene protection
profiles.
• Remove the protection moldings around the smaller
carton box.
• Remove the small box housing the motor.
″ ″
″
″ ″ ″
Wood
Mounting
Support
Hood
Parts
Package
Shipping Carton
Motor