Gefen 1080P - Manual (Page 46)

page | 36
RS-232 / IP Commands
Advanced Operation
#rmtiradd
The #rmtiradd command sets the IR channel of the matrix. The specified IR channel
must match the IR channel of the included IR remote control unit. See Setting the IR
Channel for more information.
Syntax:
#rmtiradd param1
Parameters:
param1 IR channel [0 ... 3]
Example:
#rmtiradd
Please wait...
Function completed
#rstip
The #rstip command resets the IP configuration and routing state to factory-default
settings. The matrix must be rebooted after executing this command. To reset only the
routing states to factory-default settings, use the #fadefault command.
Syntax:
#rstip
Parameters:
None
Example:
#rstip
Please wait...
Function completed