Grundig G5 - Manual (Page 13)

STORING STATIONS INTO MEMORY continued
3. Press the PAGE/TIME button to place the G5 into MEMO mode.
4. To select the desired memory page (00-99) use the buttons
or hold down the STORE button and use the tuning knob.
5. While holding down the STORE button, press one of buttons F1-
7, storing the station into that memory. Note that a box appears
around the selected memory location.
6. Release the STORE button.
7. To store another station, tune to the station and repeat steps 4-6
above.
8. When finished storing stations, press the PAGE/TIME button to
exit MEMO mode.
The G5 has 4, independently programmable alarm timers (buttons
F1-4) to turn it on at a specified time. Additionally, each timer
can be programmed for a specific weekday, volume, playtime and
memory location.
To set an alarm:
With the G5 turned off, perform a long press of one of the
F1-4 buttons (about 3 seconds), causing the hour to flash.
Use the tuning knob to set the hour; and press one of the F1-
7 buttons to highlight the day of the week for turn on.
Press the PAGE/TIME button.
Use the tuning knob to set the minutes.
Press the PAGE/TIME button.
Use the tuning knob to set the wake-up volume.
Press the PAGE/TIME button.
Use the tuning knob to set the wake-up alarm’s play minutes.
Press the PAGE/TIME button.
Use the tuning knob to set the page number or select no
page number by selecting ----.
Press one of the F1-7 buttons to select the memory location
on the selected page (the square flashes).
Press the PAGE/TIME button to finish the set-up. 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
SETTING ALARMS 1 THROUGH 4
11
G5 OWNER’S MANUAL G5 OWNER’S MANUAL