Graco PRECISIONSWIRL 310554V - Manual (Page 22)

PrecisionSwirl Module Operation
22 310554V
Setting Operation Modes
The PrecisionSwirl module has two operating states:
• Automatic mode — enables the PrecisionSwirl
orbital dispenser to be controlled by a remote signal
source, such as a robot control. Motor speed can be
controlled by a 0-10 VDC analog signal.
• Manual mode — enables the PrecisionSwirl orbital
dispenser to swirl when you press the
RUN/ENABLE button on the control assembly.
Swirling continues until the STOP button is pressed.
The PrecisionSwirl orbital dispenser is in an idle state
until you press the RUN/ENABLE button on the control
assembly. The only time the PrecisionSwirl orbital dis-
penser can swirl material is when the RUN/ENABLE
button is pressed in either Automatic or Manual mode.
When the STOP button is pressed, the PrecisionSwirl
orbital dispenser becomes idle and will not swirl mate-
rial.
The procedures in this section configure the module for
manual or automatic operation.
F IG . 12
0/7%2 -/4/2 25.
-!).
25.
#/.42/,
!54/-!4)# -!.5!,
-!.5!,
8030A
Material flow rate and “ON/OFF” flow are not con-
trolled by the PrecisionSwirl orbital dispenser.
These must be controlled by the other interfaces.
Contact your Graco Distributor for assistance.