Genie Z-34 - Manual (Page 20)

Operator's Manual Fourth Edition • Third Printing
18 Z-34/22 IC Part No. 1000048
FUNCTION TESTS
At the Platform Controls
Test the Emergency Stop
15 Turn the key switch to platform control and
restart the engine.
16 Push in the platform red Emergency Stop button
to the off position.
Result: The engine should turn off and all
functions should not operate.
17 Pull out the red Emergency Stop button and
restart the engine.
Test the Horn
18 Push the horn button.
Result: The horn should sound.
Test the Foot Switch
19 Push in the platform red Emergency Stop button
to the off position.
20 Pull out the red Emergency Stop button to the
on position but do not start the engine.
21 Press down the foot switch and attempt to start
the engine by moving the start toggle switch to
either side.
Result: The engine should not start.
22 Do not press down the foot switch and start the
engine.
23 Do not press down the foot switch. Test each
machine function.
Result: The machine functions should not
operate.
Test Machine Functions
24 Press down the foot switch.
25 Activate each machine function control handle
or toggle switch.
Result: All boom and platform functions should
operate through a full cycle.
Note: Control the speed of boom functions by
adjusting the boom function speed controller.
Drive and steer functions are not affected by the
boom function speed controller.
Test the Steering
26 Press down the foot switch.
27 Depress the thumb rocker switch on top of the
drive control handle in the direction identified
by the blue triangle on the control panel.
Result: The steer wheels should turn in the
direction that the blue triangles point on the
drive chassis.
28 Depress the thumb rocker switch in the direction
identified by the yellow triangle on the control
panel.
Result: The steer wheels should turn in the
direction that the yellow triangles point on the
drive chassis.